As pictured.
ECHUCA
The ECHUCA is typical of many vertical stationary single cylinder steam engines used in the 19th and early 20th century in Australia. Engines of this type were use in the gold fields, saw mills and small factories.
By adding Stephenson's reversing linkage the Echuca becomes a marine steam engine capable of powering model steamboats up to five feet on a boiler pressure of about 40 psi. The Echuca is an ideal project for the novice or more experienced model engineer and can be machined on a smaller (3 ½ inch) hobby lathe,
Width 3-1/2"
Height 5-1/4”
Bore 3/4"
Stroke 3/4"
Flywheel diameter 3-1/8”
Weight 1040 gms (when finished)
Click Here to view dimension outline drawing
Click Here to view the main General Assembly drawings that give a clear view of the structure of the engine.
Click Here to view extracts from the full Machining Plan Manual, supplied with the casting set, that show the more demanding components supplied with the kit to enable you to assess machining requirements for these castings.
